Ubiquiti Networks UniFi AP Pro Podręcznik Użytkownika Strona 11

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 63
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 10
8
Chapter 2: InstallationUniFi
AP-PRO and AP-AC User Guide
Ubiquiti Networks, Inc.
Hardware Installation of the UniFi
AP-AC
The UniFi AP-AC can be mounted to the wall or ceiling.
Perform the steps for the appropriate installation:
Wall Mount
1. Position the Mounting Bracket at the desired location
on the wall with the cable feed slot pointed towards
the floor.
2. Use a pencil to mark the four mounting holes. Use a 6
mm drill bit to drill the mounting holes.
Top
Optional 25 mm Hole for
Ethernet Cable Feed through Wall
3. Follow the instruction for your type of Ethernet cable
feed:
- Feeds Through the Wall Cut or drill a circle
approximately 25 mm in diameter, just below the
bottom center of the Mounting Bracket (as shown
above). Then feed the CAT5/6 cable through the hole.
- Feeds Along the Mounting Surface Remove the
Cable Feed Plug on the side of the UniFi AP.
4. Insert the M3x20 Screw Anchors into the 6 mm holes.
Secure the Mounting Bracket to the wall by inserting
the M2.9x20 Screws into the anchors.
5. Connect the Ethernet cable to the Main port. If the feed
is along the mounting surface, feed the cable through
the Cable Feed of the UniFi AP.
MAIN SECONDARY
RESET
This device complies with Part 15 of FCC rules.
Operation is subject to the following 2 conditions:
1) this device may not cause harmful interf erence
and, 2) this device must accept any interf erence
received, including interference that may cause
undesired operation.
FCC ID: SWX-UAPAC IC: 6545A-UAPAC
0560
M/N: UAP-AC 48V 0.5A POE
AP AC
|
6. Align the slots on the UniFi AP with the tabs on the
Mounting Bracket.
7. Slide the UniFi AP down until it locks into place.
Przeglądanie stron 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 62 63

Komentarze do niniejszej Instrukcji

Brak uwag