Ubiquiti Networks UniFi AP Pro Podręcznik Użytkownika Strona 8

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 63
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 7
5
Chapter 2: InstallationUniFi
AP-PRO and AP-AC User Guide
Ubiquiti Networks, Inc.
Chapter 2: Installation
Introduction
Installation Requirements
CAT5/6 cable
Phillips screwdriver
Drill and drill bit (6 mm for wall-mounting or 3 mm for
ceiling-mounting)
Optional: Drywall or keyhole saw (to cut 25 mm hole for
Ethernet cable feed)
Instructions
Proceed to the hardware instructions for your UniFi AP
model:
UniFi AP-PRO The instructions are below.
UniFi AP-AC Go to “Hardware Installation of the
UniFi AP-AC” on page 8 for instructions.
After you install the hardware, proceed to “Software
Installation” on page 10.
Hardware Installation of the UniFi
AP-PRO
The UniFi AP-PRO can be mounted to the wall or ceiling.
Perform the steps for the appropriate installation:
Wall Mount
1. Position the Mounting Bracket at the desired location
on the wall with the cable feed slot pointed towards
the floor.
2. Use a pencil to mark the three holes on the wall. Use a
6mm drill bit to drill the holes.
Top
Optional 25 mm Hole for Ethernet
Cable Feed through Wall
3. Follow the instruction for your Ethernet cable feed:
If your Ethernet cable feeds through the wall, cut or
drill a circle that is approximately 25 mm in size and
lines up with the cable feed slot.
If your Ethernet cable feeds along the wall, remove the
Plug on the side.
4. Insert the M3x20 Screw Anchors into the 6 mm holes.
Secure the Mounting Bracket to the wall by inserting
the M2.9x20 Screws into the anchors.
5. Connect the Ethernet cable to the Main/48V port on
the UniFi AP-PRO.
6. Align the notch on the UniFi AP-PRO with the notch on
the Mounting Bracket.
Przeglądanie stron 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 62 63

Komentarze do niniejszej Instrukcji

Brak uwag